Laedi Cast Orthopedic Casting Bandage, 12.5CM X 3.6M 10roll/box

"In case of fracture or other orthopedic injuries, the LAEDI CAST greatly improves treatment effectiveness by maintaining the fixed condition of the injured area and protecting it. LAEDI CAST has good conformability and moldability making it an ideal casting tape for most orthopedic applications where rigid immobilization is required, including fresh or unstable fracture.

FEATURES & BENEFIT

1. Light weight, Excellent molding, Smooth Finish

2. Setting time 3-5 minutes, functional strength in 30 minutes

3. Comfortability : Smooth unrolling offers doctors can wrap it with less pressure and patient will have no pains during the applying procedure.

4. Excellent X-ray translucency instructions. X-RAY photographing is possible.

5. 20 times stronger, 5 times lighter than conventional plaster of paris bandage.

6. Excellent ventilation, less irritation and itching.

7. Less dust during removal by cast cutter saw.

HANDLING & STORAGE

1. For PROFESSIONAL use only.

2. Avoid eye contact and skin contact. Wash exposed areas thoroughly with soap and water.

3. Store away from heat and direct sunlight.

PRECAUTION:

1. Each roll should be gently squeezed prior to opening to check suitability for application. The unopened roll should be soft and flexible, do not use the roll that feels hard.

2. An uncomfortable increase of heat can be caused during hardening by excessive layering of tape or immersing in water at temperature above 27℃.

HOW TO USE:

1. Apply a stockinette and undercast padding over the desired area to be casted. Slip on a stockinette up the affected part and wrap with cast padding.

2. Select proper width of the cast. Wear protective gloves. Open only one roll at a time, since room humidity will initiate hardening.

3. Immerse LAEDI CAST in water with room temperature (20-25 Degree Celcius ) for 5-10 seconds and squeeze 3- 5 times. Gloves must be worn while wrapping the casting tape, since the resin in the tape with room temperature (20-25 Degree Celcius ) for 5-10 seconds and squeeze 3- 5 times. Gloves must be worn while wrapping the casting tape, since the resin in the tape will adhere to the skin.

4. Squeeze the tape gently to remove excess water.

5. Wrap the desire area. Do not apply tightly. Moulding and forming should be done at this time. Setting time is approximately 3-5 minutes. Construct the cast by wrapping spirally over padding the previous turn one-half to two-third the width of the cast. Functional strength will be achieved about 3-4 minutes after immersion in water. Sufficiently rigid to prevent further moulding.

6. Smooth and rub the tape to achieve good adhesion. Just three or four layers provide a strong non-weight bearing cast and five to six layers are typically adequate for weight-bearing cast.

7. After application, allow 20-30 minutes before applying loads to weight-bearing casts.

Registered under Act 737

MDA No : GA3946924-187928

Advertisement approval number: MDAMD 0168/2025"