Directions For Use - Please read before use
1 Open the front cover by pressing the button on top of the dispenser and take out the refill can. Ensure the switch is at OFF position.
Then turn the dispenser to the side with the batteries holder facing you.
2 Pull the plastic tap from the batteries to activate the batteries.
3 Place the refill in its position with the nozzle facing away from your face and eyes.
4 Ensure that the nozzle is facing outward, away from your face and
eyes. Choose desired interval by switching to 8, 15 or 25 minutes.
The dispenser will spray once immediately, to indicate that it is
properly functioning. Once the dispenser is activated, a green light will blink every 10 seconds to indicate the dispenser is operating.
While the dispenser is functioning, do not insert finger between the gear as the gear rotates at the set intervals.
5 Close the cover and place Ambi Pur InstantMatic in your preferred location, hang on the wall or simply place on flat surface. At least 2m above floor level.
To insert or replace refill can and/or batteries
1 Repeat step 1 from the Directions For Use.
2 Ensure that the POWER is switched OFF before proceeding.
Remove the empty refill can or weak batteries.
3 Ensure that the gear is pushed all the way up (as shown in diagram A) so that the new refill nozzle can be fitted correctly into the dispenser.
4 If gear is down (as shown in diagram B), push the lever all the way up.
5 Insert the new Ambi Pur InstantMatic refill. Ensure that the nozzle faces outward to the sides at all times.
Ensure the bottom of gear touches the tip of the refill nozzle.
6 Repeat steps 4 and 5 from the above Directions For Use.
Note:
1. After selecting the desired spray interval, the dispenser will spray once immediately, to indicate that it is properly functioning.
2. If there is no blinking green light when refill can is put on, please check if batteries need to be replaced. Use Alkaline batteries only. N/ACaution
Please read the following instructions carefully before use